Sawmill Alignment
Complete Alignment Procedure
Sawmill Alignment
HD97doc041910
7-40
7
See Figure 7-34.
To tilt the arm out away from the blade, loosen the front nuts on the
inner rollers and tighten the rear nuts. To tilt the arm in toward the blade, loosen the rear
nuts on the inner rollers and tighten the front nuts. Recheck the blade guide arm horizon-
tal tilt.
5.
Now check the vertical tilt of the blade guide arm. Move the saw carriage so the blade
guide arm is positioned over a bed rail.
6.
With the arm 1/2" (15 mm) from fully closed, raise or lower the saw head until the bottom
of the blade guide block is 15" (375 mm) from the top of the bed rail.
FIG. 7-34
Adjust inner rollers
in to tilt arm in; adjust
inner rollers out to tilt arm out
3H0802-7B
