Setup & Operation
Starting The Motor
3
3-12
15doc080113
Setup & Operation
See Figure 3-11.
To adjust where the blade travels on the blade wheels, use the cant control bolt.
If the blade is too far out, back the blade onto the wheel by turning the cant control counterclockwise.
If the blade is too far in, turn the cant control clockwise until the gullet of the blade is the correct
distance from the front edge of the wheel.
4.
Adjust the blade tension if necessary to compensate for any changes that may have occurred while
adjusting the cant control.
5.
Close the blade housing cover.
DANGER!
Make sure all guards and covers are in place and
secured/closed before operating the sawmill. Failure to do so may
result in serious injury.
IMPORTANT!
After aligning the blade on the wheels, always double-check the blade guide spacing
and location. (
for more information.)
3.5
Starting The Motor
See the appropriate manual supplied with your specific motor configuration for starting and operating
instructions.
IMPORTANT!
When starting the machine for the first time, check that main
motor rotation direction is as indicated by the arrow located on the motor body
(fan guard). If the rotation direction is incorrect, invert the phases in the phase
inverter located in the power socket (electric box). Setting the phases in the
phase inverter correctly will ensure correct rotation directions of all sawmill
FIG. 3-11
15B017_D
Cant Control Bolt
!