LubeMizer Installation
Water Lube Bottle Conversion and Hose Line Installation (All LT30/LT40 Sawmills)
1
1-13
LMS99doc032619
LubeMizer Installation
1.5
Water Lube Bottle Conversion and Hose Line Installation (All
LT30/LT40 Sawmills)
1.
Reinstall the bottle to the mill.
2.
Reinstall the fuel bottle. If necessary, resecure the fuel line hose clamps.
3.
Remove the entire blade guide roller and block assembly from the sawmill.
4. Sawmills equipped with Roller-Only blade guides:
Remove the roller from the block
and install it to the provided lube blade guide block assembly.
5.
Wrap the threads of the provided fittings, nozzles and plug with teflon tape (pipe tape)
and install the components to the blade guide block as shown in the following graphic.
NOTE:
An extra nozzle is provided for service replacement.
6. Sawmills equipped with Roller-Only blade guides:
Install the lube block assembly to
the mill.
7.
Orient the nozzles so that oil flow is directed on the blade.
8.
Locate the provided 1/4" hose. Insert one end to the pump valve as shown. Route the
hose through 1/2" hose clamp. Continue routing through the grommet in the motor mount
and connect the remaining end to the fitting on the block assembly. Use wire ties to
secure the hose near the motor mount and again at the block assembly as shown.
See Figure 1-9.
