Setup & Operation
Alignment
3
3-6
SBEdoc072519
Setup & Operation
4.
Use a C-clamp to secure the string to the rear frame cross tube, maintaining the string
alignment to the front fence.
5.
Measure the distance between the face of the blade and the string at each end of the
blade. The measurements should be the same as the front fence setting (5 inches) at
both ends.
See Figure 3-6.
6.
If necessary, loosen the blade shaft bearing mount bolts and adjust the position of the
blade. Retighten the bearing mount bolts. After adjusting the blade, loosen the blade filler
plate thumb screws and adjust the plate close to, but not touching the blade. Retighten
the thumb screws.
FIG. 3-6
SB0001-16
With string flat against front
fence, measure the distance
from the string to the blade
tube at both ends
Loosen blade shaft
bearing mount bolts
to adjust position
of blade
After blade is adjusted, loosen
thumb screws and adjust blade
filler plate close to, but not
touching the blade
