Setup & Operation
Setup
Setup & Operation
SBEdoc072519
3-1
3
SECTION 3 SETUP & OPERATION
3.1
Setup
CAUTION!
Before operating the Edger, be sure to remove
the shipping block from under the blade cover. Failure to do
so will cause damage to the machine.
1.
A shipping block supports the blade guard during factory shipment. Remove this block
before operating the Edger. To remove:
Loosen the two mount knobs on the right side of the blade guard. Lift the guard from
the machine and remove the shipping block.
Replace the blade guard. Retighten the mount knobs.
2.
Unfold the rear leg. Swing the leg all the way down until they lock in position. Be sure the
pivot bolts seat in the brace notches.
WARNING!
When setting up or transporting the Edger,
avoid areas marked as pinch points. These are located
near the rear folding leg and the engine pulley. Keep your
hands away from these areas to prevent injury.
See Figure 3-1.
FIG. 3-1
Loosen
Mount Knobs
Lift blade guard
& remove
shipping block
Swing rear leg
down until locked
in position
(See Detail)
DETAIL
SB0001-10B
