SETUP & OPERATION
Feed Operation
Operation
EGdoc030112
4-22
4
4.5.5 Feed Operation
1.
Set the key in
position.
2.
Push the power feed switch to move the head forward or pull the switch to move the head backward.
See Figure 4-6.
3.
It is possible to adjust the cutter right or left. The maximum adjustment available is 110mm. To slide
the cutter, first loosen the locking knobs (4). Use the cutter scale to measure the distance from the
initial position. (When the cutter is in the extreme left position, the cutter scale shows 0.)
IMPORTANT!
Always make sure that all locking knobs are firmly tightened before using the moulder.
FIG. 4-6
WMM083
