Page 16 / 28
1. Press and hold
“Set” to enter the programming menu, scroll to “weekly” and press “Set”. Programming will start
with Sunday.
2.
Press “Set” and scroll up or down to adjust the start and end time, then the set point and “Yes” or “No” for
whether you want the stove to run during that time period (must begin with yes).
3. Press set to advance to the next time section and repeat the programming process.
4. Settings for one day may be copied to all other days of the week
(scroll to the bottom, press “Set”, scroll to “All”
and press “Set”) or program each day individually for all 4 time slots for all 7 days.
In the default
screen, press “Back” to see the current 4 “weekly” set points for the day.
Hold Temp
Pressing “Hold Temp” while in the “Heating” phase in “Weekly” mode will hold the current temperature set point and
ignore the weekly programming until pressed again or “On/Off” is pressed to shut the stove down.
Temporarily Override A Weekly Programmed Set point
You can override a programmed set point by pressing the up or down arrows to obtain a set point that the stove will run at
until the next programmed set point.
Fireoff (Shutdown)
If there is ever a problem with the stove, “ON/OFF is pressed to shutdown the stove or you cycle through the controls
modes and stay on “Weekly” for more than 5 seconds at a time of day where the stove is at a programmed time section
that is set for the stove to be off (all 28 program points by default are this way), the stove will enter a
“fireoff” phase. This
will start a 30 minute shutdown in which the blower and exhaust fan will continue to run on high and the stove will cease
to feed pellets until the exhaust temperature has dropped below 125F to ensure there are no burning pellets left. The 30
minutes (time left is displayed) must expire before being allowed to run again in any mode.
You can override the “fireoff” phase by pressing “Hold” for 3 seconds.
WARNING! Only perform this if the fire has
gone completely out
(controller should read “OFF”). Doing so while there is still pellets burning or smoldering
will create smoke that may fill your home and possibly cause a fire.
If the fireoff phase was started by accident and
you wish to keep the stove running and the pellets have not smoldered out, press
“ON/OFF” for the controller to be “ON”,
then press “Hold” for 3 seconds to continue in “heating” mode.
Shutdown Timer
Only available in Manual or Temperature mode, press “Shutdown Timer” repeatedly to adjust between a 1-7 hour delay
(pressing again after
“7HR” will cancel the shutdown timer). The stove will automatically go into “Fireoff” mode and
Summary of Contents for NC-30
Page 21: ...Page 21 28 ...
Page 23: ...Page 23 28 ...
