Warranty
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase,
that this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will
either repair or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase
together with proof of purchase as described below. Wolo reserves the right to inspect any defect prior to settling any
warranty claim by repair or replacement. This warranty is limited as above provided and Wolo will not be responsible for
fire or other casualty or accident, due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or
natural causes.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF
THREE (3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON
FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR
OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide
with the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to
cover return shipping. Mail to:
Wolo Manufacturing Corp. One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service E-mail: [email protected]
© 2006 Wolo Mfg. Corp
All Rights Reserved.
11
.
RED WIRE
is connected to the vehicle’s fuse-block or a under dash wire that has 12-volts when the ignition is
on. The red wire is provided with an in-line fuse.
(Note: if you need to replace the fuse use a 10 amp.)
12.
BLACK WIRE
is connected to ground. Secure black wire under a metal body bolt in the dashboard area; make
sure that the METAL surface around the bolt is clean of rust and paint to make a good electrical connection.
NOTE:
Tape all connections and secure wires.
TESTING AND OPERATION
13. Put the vehicle’s ignition on so to power your Alert Siren during testing.
14.
AIR HORN BUTTON
– Push and release control button, air horn turns on/off so operator can make unique
emergency sound. The rotary knob controls the output volume of the air horn sound.
14.
Siren #1 Yelp
– Push and release control button, siren turns on/off so operator can make unique emergency
siren sound. The rotary knob controls the output volume of the air horn sound.
14.
Siren #2 Wail
– Push control button and siren turns on and stays on until control
button is pressed a second time. The rotary knob controls the output volume of
the air horn sound.
14.
Microphone
– The microphone jack is inserted into the front of the siren controller
next to the rotary knob. Press the microphone button and talk into the
microphone. The rotary knob controls the output of the air horn sound.
15.
MICROPHONE HOLDER
– Locate a mounting surface where microphone can
easily be reached . Using the microphone holder as a template, mark location of
mounting holes to be drilled.
16. Drill holes (4) on marked locations using a 3/32 inch drill bit and secure the
microphone holder with the self-tapping screws provided. See Fig. (F).
10 Amp
Drill four
3/32” holes
