WolfVision SCB-1, Instruction Manual

Page: 7 / 32

Functions SCB-1
R
5
5. FUNCTIONS
The SCB-1 can be controlled through a key-matrix or via RS-232 (SCOTI).
With the WolfVision SCB-1 Interface board the basic control functions can be done for
evaluation-purposes.
5.1 ZOOM
The SCB-1 uses an 12x zoom lens as well as a 2x digital zoom.
Optical 12x, f=5.8 to 69.6 mm (F=2.8 to 3.0)
The digital zoom is automatically switched ON at the tele end of 12x optical zoom range,
with progressive effect from 1 to 2, giving a total maximum 24x zoom ratio. Digital zoom
increases the picture element size and reduces the resolution.
Extended control of zoom:
•
Direct zoom position
•
Get current zoom position
•
Zoom speed selection (15 speeds)
•
Digital zoom can switched ON/OFF
•
OSD-message or stop of zooming when digital-zoom is entered (selectable)
5.2 FOCUS
The minimum focus distance (MOD) is below 50mm at optical wide end and below 500mm
at optical tele end, and is independent of digital zoom. If shorter distance are necessary, a high
quality close up lens is available
(see optional accessories). An Auto-Focus (AF) function is
also available (enabled by default).
Extended control of focus:
•
Direct focus position
•
Get current focus position
•
Manual Focus speed selection (15 speeds)
•
Focus can switched to Auto-Focus (permanent), One Push Auto- or Manual Focus
•
Auto-Focus region can be switched between center (AF measures in the center area of
the image) and large (measure the complete image)
•
Focus Priority: "Auto" - activates Auto-Focus by pressing a ZOOM-key
5.3 IRIS
After power-on AI, ASC and AGC are enabled by default.
Extended control of Iris:
•
Direct Iris position
•
Get current Iris position
•
Manual Iris speed selection (2 speeds)
•
Iris Priority: "Auto" - activates Automatic Exposure Mode by pressing a ZOOM-key
•
Automatic / manual: Iris, Shutter and Gain