LED LIGHT ASSEMBLY REMOVAL (WHITE GLASS)
To remove the LED light, first uninstall the unit and remove the
filters, inner side panel, and outer panel.
Uninstall the Unit
1
Turn off the power to the unit.
2
Remove the unit from the installation.
TIP: Removing the internal blower first may make uninstalling
the unit easier.
Remove the Inner Side Panel
1
Use a Phillips screwdriver to remove the screws that hold
the inner side panel to the outer panel.
2
Rotate the inner side panel inward, so that the tabs come
loose from the frame.
TIP: It may be necessary to close the inner panel to allow
enough clearance for the inner side panel to rotate.
3
Remove the inner side panel from the unit.
Remove the Outer Panel
1
Use a Phillips screwdriver to remove the screws around the
outside of the outer panel.
2
Lift the outer panel from the unit.
Remove the LED Light Assembly (White Glass)
1
Use a Phillips screwdriver to remove the LED light bracket
screws.
2
Remove the LED light assembly from the LED light bracket.
3
Pull the LED light wire harness far enough through the hole
to access the connector.
4
Disconnect the LED light wire harness.
5
Remove the LED light from the unit.
LED LIGHT ASSEMBLY INSTALLATION (WHITE GLASS)
Install the LED Light Assembly (White Glass)
1
Connect the LED light wire harness.
TIP: The other end of the wire harness may be inside the frame
on the other side of the hole. It can be pulled through far
enough to access the connector.
2
Place the LED light assembly on the frame.
3
Place the LED light bracket over the LED light assembly.
Ceiling-Mounted Hood
LED Light Assembly Removal (White Glass) (continued)
service.subzero.com
828149 REV. A
7
