6
H O O D P R E P A R A T I O N
IMPORTANT NOTE:
If installing a duct cover, the duct
cover must be installed prior to hood
installation. See page #10 for duct
cover installation instructions or fol-
low those packed with duct cover.
1)
Remove hood filters from hood
shell.
2)
Remove center filter bank by
removing the 2 screws from each
side. DO NOT DISCARD THESE
PARTS, as they will be reinstalled after
hood installation is complete.
3)
The hood assembly is shipped with
the transition attached. The transition
is shipped upside down in the top of
the hood assembly and must be
removed and reinstalled.
4)
Detach the transition from the
hood assembly by removing the (4)
screws on the top of the hood assem-
bly. DO NOT DISCARD SCREWS.
Shipping screws are needed for the
reinstallation of the transition to
hood.
5)
Invert transition so that the 10”
round points away from top of hood.
Use screws removed from step 4.
6)
If installing a remote blower, drill
7/8” hole through framing for con-
duit wiring. See Internal Blower on
page 8 for overall dimensions and
electrical requirements. See installa-
tion instructions provided with the
blower for mounting and installation
information.
IMPORTANT NOTE:
Do not run or
remove blower electrical connections
through duct work.
I N S T A L L A T I O N
Install Ductwork
1)
Decide where the ductwork will
run between the hood and the
outside of the home. Your Wolf island
hood has a top discharge which will
run vertically.
IMPORTANT NOTE:
All hoods must
exhaust to the outdoors.
2)
When not installing an external
ventilator, always install a roof or
island cap. Connect 10" round metal
ductwork to the cap and work back
towards the hood location.
3)
Use duct tape to seal the joints
between the ductwork sections.
4)
Your Wolf island hood comes stan-
dard with a 10" round transition with
backdraft damper. It is recommended
that a backdraft damper be used in
all installations.
IMPORTANT NOTE:
Do not use duct
smaller than 10".
WARNING
To reduce the risk of fire, use
only metal ductwork.
Island Hood Top Transition
P
R O
S
E R I E S
I
S L A N D
H
O O D
I
N S T A L L A T I O N
Removing Island Hood Filter Bank