Component Access & Removal
4-7
D
Du
ua
all F
Fu
ue
ell R
Ra
an
ng
ge
e
Simmer
Orifice
Main
Orifice
Figure 4-12. Orifice Locations
Jet Holder Removal (PTS 17000000)
The jet holder is mounted to the burner support on the
bottom of the burner box. The main burner orifice is
threaded into the jet holder as well as the venturi.
To remove the jet holder, remove the grate(s), burner
head(s) w/cap(s), venturis, igniter lead wires, inner dis-
tribution ring(s), burner pan and outer distribution rings.
Then, disconnect the flexible gas tube that is mounted
to the jet holder. Now, extract the screws which secure
the jet holder to the burner support and lift the jet holder
off. (See Figure 4-10)
Deflector Shield Removal (PTS 17000000)
The deflector shield protects the spark modules and
wiring from spillage that may occur.
To remove the deflector shield, remove the grate(s),
burner head(s) w/cap(s), venturis, igniter lead wires,
inner distribution rings, burner pan, outer distribution
rings and jet holders. Now, extract the screws which
secure it to the burner support and remove. (See
Figure 4-11)
Spark Module Removal (PTS 17000000)
To remove the spark module, remove the grate(s), burn-
er head(s) w/cap(s), venturis, igniter lead wires, inner
distribution rings, burner pan, outer distribution rings
and deflector shield. Now, disconnect the wiring. Then,
extract the screws which secure it to the burner support
and remove. (See Figure 4-11)
Burner Support Removal (PTS 17000000)
The burner support is mounted to the bottom of the
burner box and acts as a spacer to keep the surface
burner components at the proper height.
To remove the burner support, remove the grate(s),
burner head(s) w/cap(s), venturis, igniter lead wires,
inner distribution rings, burner pan, outer distribution
rings, jet holders, deflector shield and spark module(s)
(if mounted on burner support)
. Now, extract the
screws which secure it to the burner box and remove.
(See Figure 4-11)
Surface Burner Orifice Removal (PTS 17000000)
Simme
r - The simmer orifice is hex shaped and
attached to the inside of the outer distribution ring. Use
a wrench to remove it.
Main
- The main orifice is hex shaped and is attached
to the bottom of the jet holder. Use a nut driver or
socket to remove it.
(See Figure 4-12)
Figure 4-10. Jet Holder Removal
Figure 4-11. Deflector Shield, Spark Module and Burner
Support Removal
Summary of Contents for DF304
