Downdraft Installation
9
wolfappliance.com/specs
Downdraft Installation
CONTERTOP CUT-OUT
•
Position the cooktop cut-out so that it is far enough
forward in the countertop for the downdraft to fit
behind it.
•
Set the cooktop in place and slide it as far forward as
possible. Center and square the cooktop with edges of
countertop.
•
Place the plastic template included with the downdraft
against the back flange of the cooktop and centered.
Trace around the template to mark the downdraft
opening.
•
Remove the cooktop from the countertop cut-out.
•
Cut the downdraft opening. Be careful not to chip the
edges of the countertop.
INSTALL THE DOWNDRAFT
•
Set the downdraft into the opening. Extend the leveling
brackets to the floor of the cabinet so the downdraft
sits straight. Note that the leveling brackets can be
removed and reattached in a different position. The
flange of the leveling bracket may have to face inward
in tight cabinet installations. Refer to the illustration
below.
•
Secure the downdraft to the countertop by holding the
downdraft against the back of the countertop cut-out
and tightening the two mounting screws (one on each
end of the unit) on the underside of the countertop.
•
Screw the leveling brackets to the bottom of the
cabinet. Tighten the screws holding the leveling
brackets to unit on each side.
MOUNTING
SCREWS
LEVELING BRACKET
FLANGE OUT
FLANGE IN
Downdraft leveling brackets.