Downdraft Installation
10
CONTROL MODULE INSTALLATION
•
Mark the center of the control module on the counter
top. Measure 2" (51) up (or left) and 2" (51) down (or
right) to locate holes for the mounting screws.
•
Carefully drill the three holes through the countertop.
Be careful not to damage or chip the countertop
surface while drilling.
•
Check the countertop thickness. Set the control
module in place and make sure the threaded studs are
long enough to allow the nylon thumbnuts to fully
engage. Thicker countertops may require that the holes
be partially counter-sunk from below.
•
Apply a bead of caulk all the way around the underside
of the control module to prevent liquids from reaching
the electrical connection or dripping through the holes
in the countertop. Position the control module.
•
From below the countertop, thread the two nylon
thumbnuts onto the studs of the control module and
hand tighten.
CONTROL MODULE CONNECTION
•
Connect the RJ45 connector cable to the back side of
the remote-mounted control module.
•
Connect the other end of the cable to the electrical
connection located on the right side of downdraft
assembly. Make sure that all connections are tight.
•
Refer to the illustration placed on the front of the
downdraft for the correct orientation of the RJ45
connector during installation into the downdraft
assembly.
Control Module
IMPORTANT NOTE:
The downdraft must be used with a
Wolf-approved control module and top cover.
The 2
3
/
8
" (60) x 6
5
/
8
" (168) remote-mounted control
module and stainless steel top cover are included with the
downdraft. Also included are mounting brackets, an RJ45
connector and mounting hardware.
The remote-mounted control module can be positioned
horizontally or vertically and located anywhere within 10'
(3 m) of the downdraft assembly and a minimum of 4"
(102) from the outer edge of any element or burner.
IMPORTANT NOTE:
Do not position the control module
where it will be in the way of cooking, where hot pans may
be placed or where hot liquids could be spilled on the
controls.
You will be required to drill three holes and connect the
control module to the downdraft assembly using the cable
provided. A 1" (25) diameter hole for the RJ45 connector
cable will be centered horizontally and vertically on the
back of the control module. Two
1
/
4
" (6) diameter holes for
the mounting screws will be located 2" (51) from the
center of the RJ45 connector cable hole.
To reduce the risk of burns or ignition of clothing by
reaching across the cooktop, the control module must
be mounted at least 4" (102) from an element or burner.