Page 9
Rear Panel
Figure 2-2: Rear Panel Layout
DC Power:
The IAM-MADI uses an external AC to 18V DC power adapter.
The adapter’s AC inlet is a standard IEC receptacle for 100 to 240 VAC
±10%, 50/60 Hz power connection. Four regional AC power cords, supplied
per shipping region, are available.
MADI Inputs:
(1 Coax, 1 Optical) These two connectors accept 64-channel
MADI input signals.
MADI Outputs:
(1 Coax, 1 Optical) These two connectors output 64-channel
MADI output signals, reclocked from the selected MADI source. This allows
conversion from coax to fiber or from fiber to coax cable types.
Network Port:
The Ethernet network port can connect to either a LAN or to
a PC to let you customize the IAM-MADI configuration. It will also allow you
to copy system configurations from one IAM-MADI to another. Lastly, it is
used to manage IAM-MADI software and firmware updates.
Analog Outputs:
These male XLR connectors provide two balanced analog
outputs:
Left
and
Right
. The source of these signals is the mix of audio as
monitored by the internal speakers.
By design, the supplied AC mains power cord will only plug into a three-prong
grounded outlet for your safety. If the plug does not fit into the outlet, contact an
electrician to replace the obsolete outlet.
The monitor and power adapter have been tested as a combined apparatus to
verify compliance with applicable safety and electromagnetic compliance
standards. Use of another power adapter provided by the user may negate the
compliance or not perform properly. Wohler Technologies cannot accept any
responsibility for the outcome in such cases.
MADI
Fiber- SFP
(other connectors installed are not used on this model)
Network
Port
MADI
Coax- BNC
Analog Audio Outputs
(Left & Right)
DC
Power
