Page 126
Adding the DC Power Module
The DC power supply can be used with a redundant AC or DC power supply.
To install an additional power supply, position the monitor with the rear panel
facing you and follow the instructions below.
1.
Using a small Phillips screwdriver, remove the screw on the right side of the
rear of the monitor as shown in
below.
Figure 6–10: Remove Side Screw
2.
Remove the screws on the blank cover plate and remove the cover plate.
3.
Slide the power supply into the slot from the rear panel, making sure that the
power supply’s connector seats securely into the connector inside the
monitor.
4.
Screw in the two captive screws that hold the power supply in place.
5.
Attach the DC power cord to the power supply connector (4-pin XLR-M) and
plug it into an outlet protected by a different breaker.
Important
:
Keep the blank cover plate for future use. We recommend taping
it to the side of the monitor; but do not cover the air vent.
Important
:
Do not sort the DC wire or plug connecting the AMP2-16V
monitor.
