www.wobit.com.pl
Manual -SIC184 – 27.10.2014 – v.1.1
page 3
Thank you for selecting our product!
This instruction will help you at correct service and accurate exploitation of described device.
Information included in this instruction were prepared with high attention by our specialists and is description of the
product without any responsibilities within the meaning of the commercial law. Based on the information should not be
inferred a certain features or suitability for a particular application. This information does not release the user from the
obligation of own judgment and verification. P.P.H. WObit E.K.J. Ober S.C. reserves the right to make changes without prior
notice.
Please read instructions below carefully and adhere to its recommendation
Please pay special attention to the following characters:
CAUTION!
Not adhere to instruction can cause damage or impede the use of hardware or software.
1.Safety and assembly rules
1.1.Safety rules
Prior to first start-up of the device please refer to this manual;
Prior to first start-up of the device please make sure all cables are correctly connected,
Provide appropriate working conditions, in compliance with the device specifications (e.g.:
power supply voltage, temperature, maximum current consumption).
Before making any modifications to wiring connections, disconnect the power supply
voltage.
1.2 Assembly recommendation
In environments with unknown noise levels, it is recommended to follow measures described below
to prevent any possible interruptions of the device operation:
Ground or reset metal rails, on which are mounted instruments,
Do not power devices on the same line as the device without a corresponding high power
line filters;
Please use screening of the supply, driver and signal cables, with the ground for the screen
should be connected only on one side, as close to the device;
For motor power supply please use twisted pair cables, and if possible use a ferrite bead
assumed on the wire;
Please avoid of leading control cables (Signal) parallel or in close to electrical and power
wires;
Please avoid proximity to devices that generate high levels of electromagnetic interferences
and/or pulse (high-power loads, the burden of the phase or power control group).
