WM W-1904-P, Operator'S Manual

Page: 15 / 70

W-1904-P QUAD DUAL SIDE GRINDER
Revised 1-2014
14
LOADING SAW
SET UP (CONTINUED)
4. Tighten Band Saw Hold Down at each end of the Saw Clamp Bar. If too tight the index will
not be able to slide back, and if too loose the band saw will lift up when indexing.
5. After making sure the Index Finger is in the gullet, turn Switch (G) to Run. This will close
the Clamp Jaws. Move Joy Switch (B) to the left until a tooth passes the Index Finger. Then
allow Joy Switch (B) to return to center position.
6. At this time a saw tooth should be against the Index Fingers. If the index stroke is insuf-
ficient, adjust as shown on page 10
7. Set Tooth Counter (C) on the number of teeth to be ground.
8. Place Joy Switch (A) in center position, pull Start button.
9. After coolant flow is on tip, place Joy Switch (A) into Automatic #1.
10. The grinding head will travel down and grind a tooth. Set speed and stroke as neces-
sary.
11. Adjust In-Feed knobs as necessary on the grinding head to achieve desired finish kerf
width. Set speed and stroke as necessary.