W-1904-P QUAD DUAL SIDE GRINDER
Revised 1-2014
3
GENERAL SAFETY RULES
Failure to follow the safety rules and other basic safety precautions, may result in serious
injury.
Always use eye protection:
When operating this machine, eye protection should be worn. Grind-
ing particles and the possibility of wheel breakage make eye protection necessary. Also face or
dust mask if operation is dusty. Use adequate ventilation.
Use ear protection:
If operation is creating excessive noise.
Disconnect power:
To machine when NOT in use.
Keep Clear:
Of grinding wheels and pinch points when machine is running.
Don’t over reach:
Keep proper footing and balance at all times.
Saws are sharp:
Wear appropriate personal protective equipment when handling saw blades.
Mounting of wheels:
Should only be done by persons with mechanical aptitude and good knowl-
edge of mounting, care, and inspection of grinding wheels. Wheels must be rated for the RPM of
the machine.
Dress properly:
Do not wear loose clothing or jewelry. Nonskid foot wear is recommended. Wear
protective hair covering to contain long hair.
Avoid dangerous environments:
Don’t use in wet location. Keep work area well lit. Do not use
this machine in the presence of flammable liquid or gasses.
Keep children away:
Do not let VISITORS contact this machine.
Keep work area clean:
Cluttered areas invite accidents.
All electrical covers:
Must be in place before applying electrical power to this machine. Electri-
cal service must be locked out prior to removing any electrical covers on machine guards. Access
to electrical components must be restricted to trained personnel only to avoid possible electrical
shock.
Voltage greater:
Than specified on name plate can result in serious injury to user.
Never stand on this machine:
Serious injury could occur if the machine tipped or if the grinding
wheel is accidently contacted.
Follow safety precautions:
For the wheels, coolant and material being ground. This information
is available on the Safety Data sheet for each of these products.
Summary of Contents for W-1904-P
