WIZ200WEB User’s Manual
© Copyright 2007 WIZnet Inc. All rights reserved
29
1)
Connect the AVRISP cable to J9 of the Base Board.
2)
Connect the power adaptor and turn on the switch.
3)
Execute AVRStudio.exe
4)
Select Atmega128 at the Device section
5)
Select HEX file at the FLASH section
6)
Click Program button.
For more detail, refer to ‘AVR Tool Guide.pdf’.
Figure 26. ATmega128 ISP
In order to update the firmware through network, the bootloader should be programmed first.
Bootloader is written to be input at 0x1E000. For the re-programming the firmware file, remove
the Atmega128 and program the ‘Boot.hex’ file. At this time, do not check the option of “Erase
Device Before Programming” for not removing the bootloader.