16
Wizard™ International, Inc., 4600 116th St. SW, PO Box 66, Mukilteo, WA 98275 888/855-3335 Fax: 425/551-4350
wizardint.com
Installing the ST 500 Straight Line Trimmer
Slide on the Straight Line Trimmer
NOTE: A Blade has been installed, so take care when handling the Straight Line Trimmer.
1. Look at the backside of the Trimmer and locate the T-Nut on the glides (Fig A). Make sure that the T-Nut
lines up with the glide on both the upper and lower sections of the Trimmer.
2. Holding the Straight Line Trimmer steady (a second person helps here), carefully slide the Trimmer onto the
channels on the right side of the Board, making sure that the T-Nuts slide into the channel of both the upper and
lower rails (Fig B). Move the Straight Line Trimmer to the left until it stops (Fig C).
Fig A.
Fig B.
Fig C.
Fig A: Make sure the T-Nut lines up to the glide. Fig B: Carefully slide Trimmer onto the channels on the right side of
the Board. Fig C: Slide Trimmer until it stops.
Lock the Straight Line Trimmer in Place
1. Slowly tighten the bottom locking knob COUNTER-CLOCKWISE until it is snug (Fig A).
2. Slowly tighten the top locking knob CLOCKWISE until it is snug. You will calibrate it after the air lines are
hooked up (Fig B).
Fig A.
Fig B.
Fig A: Turn bottom knob Counter-Clockwise. Fig B: Turn top knob Clockwise.
