\Manuals\GettingStartedManual8500eRev2
10/02/08
9
MatDesigner
™
- Getting Started Manual - Model 8500e
4. Unscrew the two Air Lines on the bottom back of the Board, and make sure that the Air Lines on the back of the Board are
not pinched as you place the Board on the Stand. Reattach the Air Lines on the inside of the Stand Arms to ensure maximum
air flow.
Fig A.
Fig B.
Fig C.
Fig A: Board in the Box. Fig B: Carefully lift the Board straight up from the box and remove foam corners. Fig C: Make
sure the Air Lines are not pinched between the Board and the stand.
5. Place the foam corners back into the box. Save packaging, foam corners and Shipping Blocks (removal instructions below)
for future use. See Contract Section 1, "Shipping Charges".
*NEVER SKIP AHEAD ON ANY STEP! Never pull/push on the Drive Shaft to
move the Gantry. Use the Gantry Arm.*
Fig D.
Fig D: Use the Gantry Arm to move the Gantry, not the Drive Shaft. The Drive Shaft is the thin cylindrical bar located
on the left side of the Gantry. The Gantry Arm is the rectangular housing on the right side of the Gantry.
