10
Wizard™ International, Inc., 4600 116th St. SW, Mukilteo, WA 98275 888/855-3335 Fax: 425/551-4350
wizardcutters.com
CMC
8000RC/FrameShop
20-71034-1
GettingStartedManual8000RCFrameShop
http://info.wizardint.com/KB/default.aspx#pageid=getting_started_manual_8000_rc
04/05/19
Check Squareness
Check the Drive Belt Lines
1. Move the gantry all the way to the left. Move the gantry slowly
toward the right until a red mark is visible on the drive belt of the
upper gantry. Confirm that the red mark lines up with the red mark
on the drive pulley.
Without moving the gantry, look at the lower drive belt of the
gantry and make sure the red mark lines up on the lower drive
belt and the drive pulley. If they do not, call the Help Desk.
Head Installation
Install the Head onto the Gantry
Do not pick up the Head using the Blade Depth
Knob.
1. Remove the two 5/32" screws from the head and set aside.
2. Move the gantry to the right edge of the CMC.
3. Point the head so that the foot block faces toward the CMC and the wheels are
close to the bottom of the gantry.
4. Line up the wheels on the head to the center channels of
the Gantry arm. Ease the Head onto the gantry arm and ease
the head onto the gantry.
5. Roll the head up on the gantry until it lines up to the head grabber arm
(attached to the right side of the gantry).
