Witt Sensoric LIGI-10 FLEX Series, Original Operating Instructions

Page: 7 / 24

Sensoric
Sensoric GmbH Berlin © www.witt-sensoric.de
7
Sensoric
Alignment mode
Alignment mode is accessed by activating test or alignment mode for at least 15s and for the
duration of alignment.
For SSR (solid state relay) output versions, the test input must now be disconnected from the
fixed potential again and connected to the test input of the controller.
The test input (T00 version) is only required for alignment when using the OSE output ver-
sions. Connect to 0V/GND in normal operation.
Receiver
Excess gain less than 2 Green LED flashing
Excess gain greater
than 2
Flash frequency of red
LED increases with signal
reserve
Transmitter
Alignment mode
(LEDs flashing alternately)
Legend
LED lit
LED flashing
LED off
green
yellow red
Transmitter Receiver