www.witeg.de
witeg Labortechnik GmbH, HG-15A Homogenizer
11
7. Stick the device at the body holder.
8. Tighten the bolds with the included Allen key carefully.
9. Stick the dispersing tool into the device and tighten the screw.
10. Check that each connection fits close.
11. Before you connect the device with the electrical outlet, please let some time laps until
the device is acclimatised.
12. Make sure that you follow all safety instructions.
13. Connect the device with the power outlet.
14. Switch the device on.
15. Set your values and start the process (look at point 6).
Never run the device without any load and dip it into the medium which should
be homogenized before powering on the device. Overspeed and resulting
vibrations can damage the device.
Don´t push the homogenizer constantely against the vessel, if you are
homogenizing inside a glass vessel. High frequent vibrations could damage your
glass vessel.
6 Job description
Switch the device on and turn the knob to set the speed.
7 Maintenance and cleaning
Please read the whole safety instructions before you start to maintain or clean the device
and pull the power plug out of the electrical outlet.
Only use care cleaning agents and soft cleaning rags.
Organic lotions, strong chemicals and rough cleaning rags can damage the device.
If you not want to use the device for a long time, pull of the power plug and keep it dry in
the package.
Only use original spare parts.
8 Technical data
HG-15A
Dimension (mm)
(w×d×h)
60x70x215
Speed (U/min)
2000 - 27.000
Dispersing capacity
up to 2,5 liters
Motor rating
input /output
(W)
300 / 160
Safety device
overheat protection
Material
Housing
powder coated steel
tools
stainless steel and PTFE (bearing)
Weight (kg)
2,5
Usable tools
HT1008
,
HT1010
,
HT1018
,
HT1025
Power supply
AC 230 V, 1N~, 50/60 Hz
