www.witeg.de
witeg Labortechnik GmbH, WCB Circulation Water Bath
15
Connect the device only to the suitable power supply. Please have a look to the
identification plate.
Use the device only in electric circuits with ground fault circuit interrupter.
Check the power supply cord before you stick it into the electrical outlet.
Do not use power bars to extend the power supply cord.
Only use extension cables with sufficient cable cross section.
Do not touch the device with wet hands during the usage because this might cause an
electrical shock.
If unexpected sound, smell or smog is generated by the device, pull out the main plug and
contact the manufacturer or your supplier immediately.
Disconnect the power supply plug before cleaning or maintenance.
If you use radiation or contaminated samples the responsibility is only up to you.
It is important that the device stands up on a horizontal, stabile and firm subsurface to avoid
vibrations.
If you set the device in a site with vibrations, make sure that the device can not slip away.
To avoid heat congestion or fires make sure that there is enough space for air circulations.
Avoid direct solar radiation.
Do not use the device near highly combustible materials.
Do not set the device outdoors.
It is superiorly to set the device in a good illuminated place to avoid accidents engendered
by handling errors.
To set the device in wet or dusty places could cause overheating, short circuits or fires.
Do not use this device in area with potentially explosive atmosphere.
Reparations and amendments should only made by
witeg
authorized people.
Contraventions exclude the warranty.
Make sure, that the safety switch is adjusted up to 30°C over max. temperature. Otherwise
the heating maybe doesn’t work.
Do not put heat-sensitive items at the device.
Warn all attendees if you leave the device unattended.
Pay attention when you lift up the lid, hot condensation water may drop down or hot steam
could come out.
