WITA go.future LCD 40 Series, Translation Of The Original Installation And Operating Instructions

Page: 34 / 40

WITA go.future LCD 40-XX | 60-XX
9.1 Assembling the power plug
Connect the power cable to the pump as shown. Caution: Line voltage! Observe the required
protective measures, national body regulations and local provisions at all times. The cable
crosssection may be no smaller than 0.75 mm
2
. Use ferrules if using fine-wire cables.
10 Filling and bleeding the system
Fill and vent the system correctly.
To vent the pump, run the venting program
described under section 7.3 IV (page 30).
After this process, you can start the pump
in the desired control mode.
Incomplete venting can lead to noises
in the pump and system.
Warning! Risk of burns!
The entire pump can be very hot,
depending on the operating state of the system.
34
Operating instrutions
18
6
13 (2x)
2
1
Click
Click
2
3
4
Note