MPR30-IFB User Manual
Rev. 03
14
Settings
The
Settings
menu allows to configure main settings of the device.
PARAMETER SETTING
MEANING
Name
12 case-sensitive alphanumeric
characters
The name menu allows to change the name of the
receiver. This is the name displayed in the top of
the Status display and it is the name sent to the
transmitter with the sync function (for the
transmitter with this advanced capability).
Use the UP/DOWN buttons to change the selected
character and push SEL button to switch to the
next character.
Quick
Menu
Clone or Off
The quick menu is displayed pushing UP or DOWN
buttons when the receiver is on the
Set to “Clone” to enter quickly to the Load clone
menu or “Off” for disable this function (if is set
“Off” and UP or DOWN buttons are pushed,
nothing happens).
Display
Contrast
0÷5
Change contrast display from 0 (min) to 5 (max).
Low timeout
5÷60 (steps 5)
Low timeout sets the timeout from 5 to 60 seconds
(5sec steps) to decrease the brightness display.
Off timeout
10÷120 (steps 10)
or OFF
Off timeout sets the timeout from 10 to 120
seconds in 10 sec. steps to turn off the display.
With OFF setting the display never turns off.
LED
Full
Alarm
OFF
3 LED setting are available:
Full: LED indicators works normally;
Alarm: LED indicators lights up only when an alarm
happened;
OFF: LED indicators remain off.
Infrared
By this menu, MPR30-IFB can be connected to IRDA for setup or firmware upgrades.
When the Infrared interface is active, the following screen is displayed.
NOTE: while in this menu display is not automatically turned off.
