WBD200
User Guide
I. Product Overview
1. Headphone Jack
2. Camera Detection Lens
3. Weak RF Signal LED
4. Weakest RF Signal LED
5. Normal RF Signal LED
6. Strong RF Signal/Battery Life LED
7. Blue Indicator Light
8. Sensitivity Wheel
9. Mode Switch
10. Power Input
11. Extendable Antenna
12. Laser LEDs
13. Laser LED Button
II. What’s in the Box
-1× Anti-Spy Detector
-1× AC110-240V to DC5V Charger
-1× Headset
III. Radio Frequency Detection
>> Before using, please make sure that the detector is fully charged.
3.1. Power on the detector by sliding the Mode Switch to the beep mode position
or the vibration mode position . The blue indicator light will be illuminat-
ed.
3.2. Push up the sensitivity wheel and extend the antenna to the longest to widen the
search scope.
3.3. If RF signals are detected, the detector will either start beeping or vibrating. You
can tell how strong these RF signals are by those 4 signal LEDs.
3.4. Gradually push back the sensitivity wheel and shorten the antenna to narrow
down to the source of the radio signal. When closest to the objects emitting RF sig-
nals, all 4 signal LEDs will be illuminated.
3.5. Slide the Mode Switch to the OFF position. The blue indicator light will be off.
IV. Camera Lens Detection
>> Before using, please make sure that the detector is fully charged.
4.1. Power on the detector by sliding the Mode Switch to the beep mode position
or the vibration mode position . The blue indicator light will be on.
4.2. Press the Laser LED Button once to turn on the Laser LEDs and they will keep
flashing. Press the Laser LED Button once again to turn off the Laser LEDs.
4.3. Press and hold the Laser LED Button. The longer you hold it, the faster these
Laser LEDs will flash. If you keep holding it long enough, these Laser LEDs will back
to flash at the initial rate.
4.4. Look through the lens and you will find a blinking red dot where the camera lens
locates at.
4.5. Slide the Mode Switch to the OFF position. The blue indicator light will be off.
V. Charging
5.1. Power off the detector and connect it to an outlet AC power supply using the
included DC5V charger.
5.2. It will take 3 hours or so to obtain a full charge.
5.3. The low battery LED will blink if the detector is running low on batteries.
