10_
installation
installation
PROTECTION OF CABLE FROM WATER
If this product is mounted outdoor, water leakage may occur at gap between cables. As shown below, butyl rubber
(available on the market) shall be used to protect from water.
1.
Connect power supply and BNC power source.
2.
Cover black sheath of the cable (Zone A), and ensure half of butyl rubber can cover the cable joint.
J
`
Poor water protection at the cable sheath may cause water leakage. Make sure to wrap tightly.
`
The water-proof butyl rubber is made of rubber that expands to twice the original length.
`
If you do not use cable joint, it must be covered with water-proof tape.
CONNECTING THE DVR
Connect the BNC connector of the camera to the enclosed 60ft camera cable, and then connect the BNC
connector of the camera cable to the BNC Video Input port of the DVR.
VIDEO INPUT
HDMI
VGA
LAN
12V
CAUTION
RISK OF EL
ECTRI S
HOCK
DO NOT
OPEN
CAUTION : TO REDUCE THE RISK OF E
LECTRICAL SHOCK
DO NOT OPEN COVE
RS. NO USE
R SER
VICEABLE
P
ARTS INSIDE. REFER SE
RVICING TO QUALIFIED
SER
VICE PE
RSONNEL.
WARNING : TO PREVE
NT FIRE OR SHOCK HAZARD. DO NOT
EXPOSE UNITS NOT SPE
CIFICALL
Y DE
SIGNED
FOR OUTDOOR USE
TO RAIN OR MOISTURE.
