33
7.10 Wrong engraving and not following the file engraving
1. Initialization is not correct, the data was sent out (please make a change)
2. Operation was not in order (need to key in again)
3. Control card problem
4. The configuration number of the software was problem
5. The driver fault or current subdivision numbers setting was different with the software.
6. Inverter interference or wire problem.
7. Electrostatic interference
7.11 Wrong size or not closing and malposition when its engraving
1. Check the edited files is correct (reset)
2. Check if the selected filed is out from the size of the layout (choose again)
3. Check the parameter settings in the software (reset)
4. Check if the tightness degree is consistent. If the timing belt is too loose, the performance will appear double image
for engraving letter; if too tight, will damage the timing belt. Please adjust the timing belt if there is something wrong
with it: To adjust the screw to suitable degree, until you get no double image for engraving letter and low noise while
running the machine.
5. Check the belt or synchronous belt is slip or Jumping over Teeth (fasten the synchronous wheel or belt)
6. Please check if the beam is parallel.
7. Please check if the pulley at the laser head abrades, that makes the laser head not hard up, you can change a new
pulley.
8. Please check if the computer system is right (please install the software again)
7.12 No output from the computer
Please check if the parameter in the software is correct (maybe you need reset)
a) When the laser machine was running, is it fixed position as first or not, after that can output the data (reset the
output)
b) Please check if the machine datum before starting the job (reset)
c) Please check the output gorge is it same as software setting (reset)
d) Please check if the ground wire is stable, and the static electricity interferes the wire (reconnect the ground wire)
e) Change the gorge and texting the output
f) Please install the laser software and test it again
