MACTek BULLET™ – User Manual
DM1101010UAB
Copyright 2009-2010
10 of 33
Set the Power Configuration for the Bullet:
1. From the Main DD screen, select Configure… (In Simatic PDM, select
Configure… from the Device menu at the top of the screen).
2. Select Guided Setup…
3. Select Configure Power Mode…
4. Follow the on screen instructions and select the proper power configuration for
the application.
Configure Burst settings
1. From the Main DD screen, select Configure… (In Simatic PDM, select
Configure… from the Device menu at the top of the screen).
2. Select Manual Setup… Burst Settings…
3. Set the Automatic Burst Mode to the desired update rate (recommended) or set
this to disabled.
4. If not using the Automatic Burst Mode, manually set the burst mode configuration
for each Burst Message.
Note: Sub-devices must be detected before configuring
the manual Burst Mode configuration.
5. Transfer the updated information to the Bullet by clicking on the “Send” or
“Transfer” button
Configure WirelessHART Network settings
1. From the Main DD screen, select Configure… (In Simatic PDM, select
Configure… from the Device menu at the top of the screen).
2. Select Guided Setup…
3. Select Join Device to Network…
4. Follow the on screen instructions and enter in the WirelessHART Network ID and
join key
5. After accepting the settings, the Bullet will attempt to join the network
Monitoring WirelessHART Network join status
1. From the Main DD screen, select Service Tools… (In Simatic PDM, select
Service Tools… from the Device menu at the top of the screen).
2. Select Communications… Wireless Status…
3. Monitor the progress of the WirelessHART join. If “Join Failed” under Join Status
becomes set, check the Network ID and Join Key that were used to see that they
are correct.
At this point, the Bullet is ready to be installed and commissioned in the field.
