10
TORCH WIZARD INSTALLATION & OPERATION MANUAL
4.0 MAINTENANCE OF CLEANING STATION & WIRE CUTTER
The Torch Wizard® is for the most part, a low maintenance peripheral. However, maintenance of this unit should still be
added to your preventive maintenance schedule. The following should be checked at regular intervals:
▶ Visually inspect unit for damage, especially
mechanically stressed components
▶ Clean the filter
▶ Check that the air lines are free of leaks
▶ Ensure the lubricator has lubricant and fill if necessary
▶ Check blade for chips or cracks, replace if necessary
▶ Check for lose parts
▶ Ensure the proper depth of blade in the nozzle
▶ Ensure the blade is not making contact with the diffuser
▶ Ensure all covers are in place before operating
Wire Cutter Maintenance (if applicable)
The wire cutter blade and back plate should be checked occasionally for wear. Replace blade (pt. #NCS-WCS-08) if worn.
If the back plate is worn, it may be removed and flipped around to the other end. To disassemble and install a new blade,
remove the two screws on the top of the cutter with a 4 mm wrench. Remove the slide piece that rests on top of the blade
and then remove the screw holding the blade with a 2.5 mm wrench. Install the new blade with the
angled side facing up
as shown in Fig. 9. Reassemble unit.
The wire back plate may be flipped by removing the screw on the bottom of the cutter with a 5 mm wrench. Replacement
blades and other wire cutter components are available from ELCo Enterprises.
The wire cutter should also be greased approximately once every 10,000 cycles with multi-purpose grease.
4mm M6
screws
Grease Zirc
5 mm M6
screw
Wire Back
Plate
Cutting
Blade
Figure 8: Wire Cutter, Exterior View
Figure 9: Wire Cutter, Interior View
Wir
e L
oc
ation
Spring
Clamping
Block
Wire Cutter Replacement Parts:
Cutting Blade
Pt. #NCS-WCS-19
Wire Back Plate
Pt. #NCS-WCS-16
Clamping Block
Pt. #NCS-WCS-07
Replacement Spring
Pt. #C0240-045-1000-S
