Wintriss SmartPAC 2, User Manual

Page: 203 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Initialization Mode 4-17
CUSTOM SENSOR NAMES (Optional)
(INITIALIZATION – CUSTOM SENSOR NAMES)
This item, which appears on the Main Initialization Menu only when DiProPAC is installed,
allows you to create “custom” names for up to 32 die protection sensors. The custom names
you create in Initialization provide the options available to you in Program mode when you
select names for your sensors. You create custom names on the Custom Sensor Names
screen, which is shown in Figure 4-12.
To create a custom name, do the following:
1.
Select CUSTOM SENSOR NAMES on the Main Initialization Menu. The Custom
Sensor Names screen displays.
2.
Select the item for which you want to create a custom name (e.g., CUSTOM 1, CUSTOM
2, etc.). The Alphabetic Entry window (see Figure 4-6, page 4-10) displays.
3.
Key in the custom name, following the directions in the Alphabetic Entry window, then
press
F6 to accept your entry. You are returned to the Custom Sensor Names screen with
You can use a separate computer keyboard to enter custom sensor names. See page 4-68.
Custom Name entries 17-32 display sequentially, one at a time as you move the highlight bar
down past the CUSTOM 16 item.
Custom names do not have to be entered in the sequence that you use to name sensors. Sensor
1 can be assigned Custom Name 32, Sensor 2 Custom Name 15, Sensor 3 Custom Name 5, etc.
See page 5-22 for instructions in assigning custom names to sensors.
Figure 4-12. Custom Sensor Names Screen
NOTICE
NOTICE