Wintriss SmartPAC 2, User Manual

Page: 254 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
4-68 Initialization Mode
2.
On the Servo-Feed Parameters screen, select FEED ADVISOR, then on the Servo-Feed
Advisor screen, select PRESS SPEED, and enter a value 10% greater than the actual press
speed.
3.
When you have changed the PRESS SPEED value, select CALCULATE.
4.
Press RESET to return to the Tool Program Menu, then press F5 (Load This Tool) to load
the tool. Cycle the press and notice whether feeding is complete at the correct time.
•
If feeding is complete at the correct time, you are finished with press speed
compensation for link motion.
•
If feeding is completed too late, switch to Program Mode, increase Press Speed in the
Feed Advisor by 3%, and calculate a new value with this setting (see steps 2 and 3).
Load the tool number, and run the press to observe the feeding again. Continue to
increase Press Speed in the Feed Advisor by 3% increments until feeding is complete at
the correct time.
•
If feeding is completed too soon, switch to Program Mode, decrease Press Speed in the
Feed Advisor by 3%, and calculate a new value with this setting (see steps 2 and 3).
Load the tool number, and run the press to observe the feeding again. Continue to
decrease Press Speed in the Feed Advisor by 3% increments until feeding is complete at
the correct time.
Using a Computer Keyboard to Enter Names
When entering the name for your press and custom names for cams and sensors, you can use a
computer keyboard connected to SmartPAC 2. To connect the keyboard and use it to key in
names, proceed as follows:
1.
Power down SmartPAC 2.
2.
Plug the keyboard into the appropriate connector on the SmartPAC 2 board (see
Figure 2-25, page 2-51).
•
Keyboard with a USB connector: Plug into the USB connector (J121).
•
Keyboard with a PS/2 connector: Plug into the PS/2 connector (J120).
3.
Power up SmartPAC 2.
4.
Select the name you want to enter (e.g., PRESS NAME), and when the Alphabetic Entry
window displays (see Figure 4-6, page 4-10), type your entry on the keyboard.
You can type any alphabetic or symbol character shown in the Alphabetic Entry window.
You can also enter numbers and use the backspace key and the space bar. As you type, the
characters appear at the top of the Alphabetic Entry window.
5.
When you have finished typing, press F6 on the SmartPAC 2 panel to accept your entry.