v3
5
Winton WSB
2. INSTALLATION & SET UP
Safety:
Ensure tractor and machine is stopped & keys out of ignition before set
-
up/maintenance.
Safety:
Before attaching/detaching machinery ensure the hydraulic lift system is in a neutral position.
Safety:
Make sure the PTO drive isn’t connected at any point until instructed to do so.
You will need:
Your tractor, tractor top link arm (adjustable), linkage pins, PTO shaft, PPE safety wear & some elbow
grease!
Attaching The Machine
Start by finding a flat piece of ground. Position your tractor and lower the three point linkage
3
to line
up with the machine. Then attach the machine to the tractor using the three point linkage pins
1
and
fix in to place with the linch pins
2
.
Adjust the top linkage arm on the tractor
12
until the PTO of the implement is parallel to the ground.
Start the tractor engine and lift the machine from the ground, then turn off the tractor engine and
remove the ignition key.
Level the machine so that both sides are parallel to the ground by adjusting the tractor’s lifting arms.
The blades must be at the same distance from the ground on both sides of the implement.
Adjust the tractor lower link arm adjusters
13
to prevent any excessive movement to the side. A
movement of about 50mm each side (2 inches) is recommended.
1
2
3
11
11
12
13
