v3
15
Winton WSB
10. SERVICING & MAINTENANCE
Safety:
Store all lubricants away from excessive heat, dust, moisture and contaminants.
Safety:
Ensure tractor and machine is stopped & keys out of ignition before set
-
up/maintenance.
Greasing & Lubrication Points
Wipe grease nipples with a clean cloth before greasing to avoid injecting any dirt and grit. Press
grease into each grease nipple three to five times. We recommend using a hand
-
held grease gun for
best results. If grease nipples will not take grease, remove and clean thoroughly. Also clean lubricant
passageway. If you notice any grease points are broken replace or repair them immediately.
Greasing The PTO Shaft x2
Grease both grease points on either end of the PTO shaft and apply grease to the inner shaft.
Greasing The Blade Rotor Bearing x1
Grease the right bearing of the rotor
1
. The left bearing is within the chain casing reservoir and is
lubricated by the oil bath. [See section on chain reservoir oil check/change].
Greasing The Roller Bearings x2
Apply grease to both of the rear roller bearings
2
. There are easy to access grease points on the left
and right of the roller on the inside of the bracket.
*The periods recommended are based on normal operating conditions. Severe or unusual conditions
may require more frequent maintenance.
Grease Type
Multi
-
purpose lithium based grease
Grease Frequency
Check every 4
-
8 hours (top up if required)
1
2
