V1
5
Winton WFM
3. CUTTING HEIGHT ADJUSTMENT
Safety: Ensure tractor and machine is stopped & keys out of ignition before set-up/maintenance.
Note: Clearance of blades to the ground should be at least 20mm and higher on un-even ground.
Getting the cutting height right is the key to creating the best cut and finish when mowing. The cut
height can be set by simply adjusting the mower deck height with the wheel spacers.
There are different sizes of adjusting spacers on the wheel forks which can be used to achieve a range
of cutting heights. The spacers are moved from under and above the wheel bracket to achieve the
desired height.
Always make sure all spacers are in the same position on all wheels to ensure an even and level cut.
Wheel Adjustment
1.
Use the tractor linkage and secure stands to raise the mower off the wheels.
2.
Remove linch pin 1 and slide wheel fork 2 out of bracket 3.
3.
Position spacers 4, 5 & 6 above or below the wheel bracket as required.
4.
Position the spring 7 on the bracket.
5.
Replace wheel fork 2 and linch pin 1.
6.
Repeat above on the remaining three wheels.
1
4
5
7
6
2
3
Summary of Contents for WFM Series
Page 20: ...V1 18 Winton WFM NOTES ...
Page 24: ...www wintonmachinery co uk ...
