Winton WFL Series, Owner'S Manual

Page: 18 / 40

V2
16
Winton WFL/WHF
8. SERVICING & MAINTENANCE
Safety: Store all lubricants away from excessive heat, dust, moisture and contaminants.
Safety: Ensure tractor and machine is stopped & keys out of ignition before set-up/maintenance.
Greasing & Lubrication Points
Wipe grease nipples with a clean cloth before greasing to avoid injecting any dirt and grit. Press
grease into each grease nipple three to five times. We recommend using a hand-held grease gun for
best results. If grease nipples will not take grease, remove and clean thoroughly. Also clean lubricant
passageway. If you notice any grease points are broken replace or repair them immediately.
Greasing The PTO Shaft x2
Grease both grease points on either end of the PTO shaft and apply grease to the inner shaft.
Greasing The Blade Rotor Bearings x2
Grease both bearings on each end of the rotor. One is on the side body panel and the other one can
be reached through the access hole in the belt guard.
Greasing The Roller Bearings x2
Apply grease to both of the rear roller bearings 2. There are easy to access grease points on the left
and right of the roller on the outside of the brackets.
Hydraulic ram for side shift x4 (WHF only)
There are two grease points underneath on the side shift frame and two on the top.
Grease Type Multi-purpose lithium based grease
Grease Frequency Check every 4-8 hours (top up if required)