Wintec G-RAYS 2 WBT-201, User Manual

Page: 6 / 51

5
Part 4
Quick user’s guide
Package: G-RAYS 2 (Bluetooth GPS with USB
cable+ sticker
＋
car cigarette lighter a power adapter ,
installation Disk, Quick user’s guide.
G-RAYS 2 Operation:
Temporarily press power button to power on it. The
Bluetooth and GPS status LED will glow to confirm it is in
GPS mode and GPS start acquisition.
GPS LED glows red to show GPS acquisition is done (1
Hz). But if this LED is solid on, the GPS acquisition fails.
Temporarily press on power button. Bluetooth will turn off
after Bluetooth LED goes off. Another press on power
button can turn Bluetooth on after its LED glows again.
After power on, press and hold power button to turn the
power off.
If Power LED (glows red) starts to blink, the power is low
and needs recharging. Power LED stays solid while
charging .It snuff out red LED and glows green LED solid
on after it is fully charged.
Temporarily press “TRACK” button (GPS LED flash green
light) to mark point in current track when log function is
enable.
Press and hold “TRACK” button (GPS LED glows green
and snuff out after 1.5 sec) to re-start new track when log
function is enable.
When the USB is used as interface:
USB driver must be installed first.
After connection to USB port of computer, place the G-
RAYS 2 at suitable area where it can best receive GPS
signal for acquisitioning.