Wintec G-RAYS 2 WBT-201, User Manual

Page: 24 / 51

23
PIN code will be requested after Bluetooth connection initiates
between GPS and Pocket PC. Enter code as 0000 .
Avoid placing 2 GPS devices too close during positioning.
Bluetooth connection takes 5 seconds for self-check. Each
time the device is switched on; it needs 5 seconds before
connection.
It is normal if the Bluetooth coverage might become short
sometimes due to environmental interferences.
USB driver must be installed first before connecting the device
to the USB port of computer. Make sure of the right Com Port
being used.
If disconnection between Pocket PC and GPS is done in a
abnormal way, Pocket PC will halt. Try to disconnect Bluetooth
connection in a standard method.
If the G-RAYS 2 is found to work abnormally because of wrong
procedure, reset it by taking off the battery. It will have factory
default without effecting pre-set program. At the factory default,
GPS reception begins in a quick start mode and its position
may take longer time.
If G-RAYS 2 is used for navigation but found unworkable after
connection is done. Make sure the format of NMEA0183 that
the software used match up G-RAYS 2 export format.