Notes About the Remote Control
If you find that the remote control must be used closer to the
main unit, the batteries are weak. Replace both batteries with
new ones.
The area between the remote control and the main unit must be
clear of large obstacles.
Do not expose the remote control sensor to strong lighting,in
particular an inverter type fluorescent lamp.Otherwise,the
remote control may not work properly. If necessary, position the
main unit away from direct lighting.
7
Getting Started
Battery Replacement
Notes
Notes
Since the remote control will be used for many of this unit's
control operations, you should begin by installing the supplied
batteries.
1.
Turn the remote control over and open the battery compart-
ment py pressing the release tab in the direction of the arrow
and lifting the cover open.
2.
Insert the batteries(AA,LR6,UM-3 TYPE) according to the
polarity markings on the inside of the battery compartment.
3.
Close the battery compartment cover.
Use AA,LR6,UM-3 batteries.
Be sure the polarities are correct.(See the illustration inside the
battery compartment.)
Remove the batteries if the remote control is not used for an
extended period of time.
If batteries leak, dispose of them immediately. Avoid touching
the leaked material and contact with clothing, etc. Clean the
battery compartment thoroughly before installing new batteries.
30
30
Within approximately
6m(19.7feet)
Installing batteries in the remote controller
Remote Control Operation Range
This remote control must use non chargable or
chargable alkaline type batteries only.