Winplus Cocoon Create Model Maker HE170703, Instruction Manual

Page: 15 / 40

15
AFTER SALES SUPPORT
1300 663 907 CUSTOMERCARE@WINPLUS.COM.AU MODEL: HE170703
SETUP
4.4 Adding Filament
The Cocoon Create ModelMaker 3D Printer can only used with PLA (Polylactic Acid BioPlastic)
filament. Only use genuine Cocoon Create filaments as using generic filaments may damage your
3D Printer and may void your warranty. Extra filament including multiple colours and PLA types
are available from the online store at
www.cocoonproducts.com.au
To add filament to your printer:
1. Place your roll of filament on the filament spool holder
2. Turn on the 3D Printer with the power switch located at the
back of the printer
3. Push the dial button to access the Main Menu and navigate
to Quick Settings Change Filament Add Filament. The
extruder will automatically raise and preheat; always wait
until it has fully preheated
4. After the extruder has preheated, hold the filament clamp
on the top of the tower and manually feed the end of the
filament through the entire tube until it reaches the extruder.
The filament will start to extrude once the extruder has
reached target temperature. Let go of the clamp so the motor can push the filament through
5. Once filament is extruding from the nozzle press back to stop extruding
6. Carefully remove any excess filament from the nozzle using the scraper. Filament is loaded
and ready to print
WARNING:
The extruder will still be hot and the scraper should be used to remove the filament from
the nozzle