Winplus Cocoon Create Model Maker HE170703, Instruction Manual

Page: 12 / 40

12
PRODUCT ASSEMBLY & INITIAL SETUP
3.1 Unboxing and Assembly
Your Cocoon Create ModelMaker 3D Printer is carefully packed to avoid damage in transit. Take
your time unpacking it. The printer is pre-assembled and requires only minimal set up before
powering on.
1. Carefully remove the 3D printer from the box and place on a clean,
level work space.
2. 2. Cut the cable tie holding the print bed to the x-axis frame. Then
remove the bubble wrapping.
3. Unscrew and remove the outer plastic nut from the filament spool
holder, then insert the nut into the side slot of the tower. Screw in the
filament spool holder into the side of the printer.
NOTE: Ensure the filament spool holder is secure and do not overtighten
4. 4. Ensure the power switch is in the OFF position, then insert the
power supply cable into the back of the 3D printer. Insert the other
end into a nearby mains power outlet. Turn on the power outlet, then
turn on the power switch at the back of the 3D printer.
5. After a few seconds, the LCD display screen will initialize and show the
home screen.
3D Printer ready.
Elapsed Time
0
Progress
Speed
100%
00:00
21