SECTION 3 –
DRIVING YOUR MOTORHOME
3-14
the rear suspension/axle will be loaded to a
weight greater than 20,000 lbs. When certain
conditions arise, air can be exhausted from the air
springs to improve maneuverability or traction
on the rear axle by operating the Tag Axle switch
(located on dash).
Tag Axle Switch Operation
Tag Dump Position
•
Press and Hold Tag Axle switch in the TAG
DUMP position for the Tag Axle air pressure
to remain reduced and maintain the
maneuverability or traction benefit desired.
Auto Dump Position
•
This mode is activated automatically when in
reverse gear, when the Tag Axle switch is in
the MIDDLE position. The Auto Dump
feature gives you better maneuverability
while driving in reverse.
Off Position
•
The Tag Dump mode is inactive when the Tag
Axle switch is in the OFF position.
NOTE: If an override event occurs while the
switch is held in the Tag Dump position,
the switch must be cycled on and off to
clear the override command.
Further Information
See the chassis manual provided in your
InfoCase for more information and precautions
on using this feature.
HAZARD WARNING FLASHERS
The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
NOTE: Move multi-function lever up or down to
cancel.
Further Information
See the chassis manual in your InfoCase for
instructions on activating, operating, and
canceling hazard warning flashers.
Tag Axle Switch
(Located on dash)
-Typical View
Hazard Warning Flashers
(Typical View - your coach may differ
depending on model)
• Pull Silver Lever outward to activate Hazard
Flashers.
