SECTION 4 –
APPLIANCES AND SYSTEMS
4-12
ELECTRONIC THERMOSTAT
(Heating and Cooling)
The Electronic Thermostat (located near the
monitor panel) controls the propane furnace, as
well as the roof air conditioners in your coach.
When controlling the settings from the
Thermostat, you must manually press the Zone
Button and set to your preference by toggling to
either Zone 1, Zone 2, Zone 3 (if equipped), or all
zones simultaneously.
Models 34B and 36M
(2 Roof Air Conditioners)
•
ZONE 1 - (1) A/C Unit in Living/Galley Area
•
ZONE 2 - (1) A/C Unit in Bedroom/Bath Area
Models 40U and 42E
(3 Roof Air Conditioners)
•
ZONE 1 - (1) A/C Unit in Bedroom/Bath Area
•
ZONE 2 - (1) A/C Unit in Living/Galley Area
•
ZONE 3 - (1) A/C Unit in Front Cab Area
The Thermostat system will operate in both
heat and cool modes, but will not allow you to
run both heat and cool modes simultaneously.
NOTE: The Thermostat does not automatically
switch between heating and cooling. You
must manually select desired system.
Heating
1. Open the LP gas tank valve by turning fully
counter-clockwise.
2. Press the System Button and select “Heat”.
3. Press the Zone Button and select desired
zone(s).
4. Press the Mode Button and toggle between
settings to select either “Gas Heat” (for
Propane Furnace) or “Heat Elec” (for Heat
Pump).
5. Adjust the temperature setpoint to personal
preference if needed. See “Changing
Temperature Setpoints”.
Cooling (A/C)
1. Press the System Button and select “Cool”.
2. Press the Zone Button and select desired
zone(s).
3. Press the Mode Button and toggle to desired
setting:
•
Cool/Auto:
Allows the fan speed to vary
depending on the cooling needs. This is the
default setting.
•
Cool High/Cool Low:
Sets the fan speed to
run continuously at high or low, but the upper
unit will cycle when cooling is needed.
•
Fan High/Fan Low:
Sets the fan to run
continuously at high or low speed. The upper
cooling unit will not run to produce cooling.
Setpoint is not adjustable in this mode.
•
Off:
Turns the upper unit off for the zone
displayed. By continuing to press the Mode
Button, you can toggle through the settings for
the zone displayed until you have reached
your desired setting. Setpoint is not adjustable
in this mode.
4. Adjust the temperature setpoint to personal
preference if needed. See “Changing
Temperature Setpoints”.
5. Once you have established the settings for
Zone 1, press the Zone Button to store settings
in Thermostat memory.
Electronic Thermostat
(Located near monitor panel)
• System
Button
• Zone
Button
• Mode
Button
• Setpoint
Buttons
• LCD
Display
Screen
