![background image](http://html1.mh-extra.com/html/winnebago/2015-ellipse/2015-ellipse_operators-manual_987456060.webp)
SECTION 4 –
APPLIANCES AND SYSTEMS
4-6
located in the utility compartment to show you
when the Solar Charge Panel is actively charging
the house batteries.
NOTE: The Solar Charge Panel is not intended
to make the coach battery system
“maintenance free.” The solar panel will
not completely compensate for
continuous low amperage draw from
components such as the propane gas leak
detector (if equipped), the dash radio
clock, and the radio station memory
circuitry, for example.
Although the Solar Charge Panel can
help to extend battery life, the coach
shoreline should be plugged in routinely
to “top off” the batteries. We also
recommend following regular battery
inspection and maintenance, especially
in cold weather.
See “Battery Care” in Section 6 -
Electrical.
Further Information
Refer to the manufacturer’s user manual
provided in your InfoCase for complete operating
instructions.
ELECTRONIC THERMOSTAT
(Heating and Cooling)
The Electronic Thermostat (located near the
monitor panel) controls the Hydronic Heating
System, as well as the three separate roof air
conditioners in your coach.
When controlling the settings from the
Thermostat, you must manually press the Zone
Button and set to your preference by toggling to
either Zone 1, Zone 2, Zone 3, or all zones
simultaneously.
•
ZONE 1 - (1) A/C Unit in Bedroom/Bath Area
•
ZONE 2 - (1) A/C Unit in Living/Galley Area
•
ZONE 3 - (1) A/C Unit in Front Cab Area
The Thermostat system will operate in both
heat and cool modes, but will not allow you to
run both heat and cool modes simultaneously.
NOTE: The Thermostat does not automatically
switch between heating and cooling. You
must manually select desired system.
Heating
1. Turn ON the Hydronic Heating System
Interior Control switch (either Diesel Burner
or Electric Element, whichever you prefer to
use).
See the Hydronic Heating System information
elsewhere in this section for further
information.
2. Press the System Button and select “Heat”.
3. Press the Zone Button and select desired
zone(s).
Solar Charge Controller
(Located in utility compartment)
Electronic Thermostat
(Located near monitor panel)
• System
Button
• Zone
Button
• Mode
Button
• Setpoint
Buttons
• LCD
Display
Screen