![background image](http://html1.mh-extra.com/html/winnebago/2010-navion-iq/2010-navion-iq_operators-manual_987448090.webp)
SECTION 10 –
SLIDEOUT ROOMS
10-4
Crank-In Procedure
1. Disengage the motor brake, which appears as
a flat “square” protrusion on the protective
boot at the end of the motor. Move the brake
lever slightly - about 1/8 turn counter-
clockwise (to left when facing end of motor).
2. Disconnect the motor power lead from the
wiring harness.
3. Use a 3/4” socket and ratchet wrench on the
motor/gearbox shaft to crank the room in.
4. Crank the room in until it is just “snugged up”.
Do not over-crank or you could damage the
gear assembly.
5. While maintaining pressure on ratchet
wrench, re-engage the motor brake by moving
brake lever clockwise (to right when facing
end of motor).
6. Reconnect motor power lead to wiring
harness.
7. Fasten slideout room travel latching device
inside the coach before driving the vehicle.
8. See your dealer for service of the slideout
mechanism before using again.
Further Information
See the slideout manufacturer’s user guide
provided in your InfoCase for further instructions
and troubleshooting information.
GENERAL SLIDEOUT CARE
•
Wipe outer seals occasionally with talc or 303
brand protectant for smooth quiet operation.
•
Clean the floors inside before retracting the
room to avoid vinyl flooring scratches or
carpet pile snags.
•
See your authorized dealer for regular
maintenance and service of the slideout
mechanism.
Motor/Gear Assembly
(Lift rear bed board to access)
-Typical Installation
1) Lift tab inside
protrusion on boot to
disengage motor brake
2) Disconnect motor
power lead from
wiring harness
3) Use 3/4” socket on
gearbox shaft to
crank room in