SECTION 7 –
PLUMBING
7-8
Further Information
For further information and operating
cautions, see the waste pump operating
instructions included in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from LP service
compartment (located on driver side).
2. Remove dust cap from sewage drain outlet
and connect sewer hose. Be sure it is firmly
attached.
3. Place the outlet end of sewer hose into
disposal opening.
4. Open the black water drain valve with a quick
pull and make sure there are no sags in the
hose. Move the hose gently about to dislodge
any waste and ensure complete drainage.
Close black water valve as soon as tank is
empty.
NOTE: DO NOT OPEN BOTH VALVES AT
ONCE. Do not open the gray tank valve
until the black tank is drained and dump
valve closed to avoid sewage back-up
into gray tank. Gray water also rinses
any black water solids from the drain
hose.
Waste Pump
(Shown with panel removed)
-Remove cap and manually turn
waste pump shaft with a screwdriver
Sewage Drain Hose
(Located in LP service compartment)
Sewage Drain Outlet
(Located ahead of rear driver side wheel)
-Typical View
Dust Cap
Sewage Drain Outlet
Black Water Drain Valve
(Located ahead of rear driver side wheel)
-Typical View
Black Water Drain Valve