Winmate IK32, User Manual

Page: 28 / 84

USER MANUAL CHAPTER 2 HARDWARE INSTALLATION
- 28 -
2.4 Jumper Settings
This section explains how to set jumpers for correct configuration of the
motherboard.
NOTE:
A pair of needle nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both
pins, the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and
2 are short. If you remove the jumper cap, the jumper is OPEN.
PIN 1-2 SHORT
PIN 3 OPEN
CAUTION
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.
Jumpers
Label Function Note
JP1 Backlight Power Selector 2x3 header, pitch 2.0mm
JP2
PWM/DC Mode Control
Selector
2x3 header, pitch 2.0mm
JP3
Panel Power Selector 2x3 header, pitch 2.54mm
JP4
VR/Chipset Control Selector 2x3 header, pitch 2.0mm
SW1
Clear CMOS 1x3 header, pitch 2.0mm